_Mannhardt's Method_, invented about the year 1858, has been practically applied on the large scale at _Schleissheim_, Bavaria. Mannhardt's machine consists of two colossal iron rolls, each of 15 feet diameter, and 6-1/2 feet length, geared into each other so as to revolve horizontally in opposite directions and with equal velocity. These rolls are hollow, their circumference consists of stout iron plate perforated with numerous small holes, and is supported by iron bars which connect the ends of the roll, having intervals between them of about one inch. Each roll is covered by an endless band of hair cloth, stretched over and kept in place by rollers. The rolls are operated by a steam engine of 12 horse power. The fresh peat is thrown into a hopper, and passing between the rolls, loses a considerable share of its water, issuing as a broad continuous sheet, which is divided into blocks by an arrangement presently to be described. The cloth, covering the rolls, must have great strength, sufficient porosity to allow water to pass it freely, and such closeness of texture as to retain the fine particles of peat. Many trials have led to the use of a fabric, specially made for the purpose, of goat's hair. The cloth for each pair of rolls, costs $160.
The peat at Schleissheim is about 5 feet in depth, and consists of a dark-brown mud or paste, free from stones and sticks, and penetrated only by fine fibers. The peat is thrown up on the edge of a ditch, and after draining, is moved on a tram-way to the machine. It is there thrown upon a chain of buckets, which deliver it at the hopper above the rolls. The rolls revolve once in 7-1/3 minutes and at each revolution turn out a sheet of peat, which cuts into 528 blocks. Each block has, when moist, a length of about 12 inches, by 5 inches of width and 1-1/4 inches of thickness, and weighs on the average 1-1/2 lbs. The water that is pressed out of the peat, falls within the rolls and is conducted away; it is but slightly turbid from suspended particles. The band of pressed peat is divided in one direction as it is formed, by narrow slats which are secured horizontally to the press-cloth, at about 5 inches distance from each other. The further division of the peat is accomplished by a series of six circular saws, under which the peat is carried as it is released from the rolls, by a system of endless cords strung over rollers. These cords run parallel until the peat passes the saws; thenceforth they radiate, so that the peat-blocks are separated somewhat from each other. They are carried on until they reach a roll, over which they are delivered upon drying lattices. The latter move regularly under the roll; the peats arrange themselves upon them edgewise, one leaning against the other, so as to admit of free circulation of air. The lattices are loaded upon cars, and moved on a tram-way to the drying ground, where they are set up in frames.