That this must be the measure of load lifted.

That without _slip_ of screw, the actual _power_ expended, will be little in _excess_ of that required to support the machine in _water_, with a slower rotation of screw.

Scientific American Supplement, No. 443, June 28, 1884 — Part 46

That in case the same _power_ is expended in water or air, the only difference will lie in the sizes and speed of engines or screws.

Scientific American Supplement, No. 443, June 28, 1884 — Part 46

That the _greater_ the speed, the _less_ weight of engine, boiler, and screw must be, and the stronger their construction.

Scientific American Supplement, No. 443, June 28, 1884 — Part 46

That, in consequence, solid metal worked down, instead of bolts and truss work, must be used.

That as the bird wing is a screw in action, and acts _directly_ between the inertias of the load and the air, the position and operation of the screw, to the load, must imitate it.

That, in consequence, machines having wing planes, driven _against_ one inertia of air by screws acting in the line, of flight against another inertia of air, lose fifty per cent. of useful effect, besides exposing to a head wind the cross section of the stationary screw wing planes and the rotating screw discs; and supporting the dead weight of the wing planes, and having all the screw slip in the line of flight, and carrying slow and heavy engines.

That as a result of these conclusions, the supporting and propelling power should be expressed in the rotation of screws combining both functions, the position of whose planes of rotation to a fixed horizontal line of direction determines the progress and speed of machine upon other lines.

That the whole weight carried by the screws should be at all times exactly below the center of gravity of the plane of support, whether it be horizontal or inclined.

That while the _permanently_ positioned weight, such as the engines, frame, holding screws, etc., may be rigidly connected to or around the screw plane of support, the variable positioned weight, such as the passenger and the car, should be connected by a _flexible joint_ to the said plane of support.

Consequently, the car may oscillate without altering its weight position under center of supporting plane, thus avoiding an involuntary alteration of speed or direction of flight.

That to steer a machine so constructed, it is merely necessary to move the point of attachment of car to _machine_ proper, out of the center of plane of support in the desired direction, and thus cause the plane of support or rotation of propellers to incline in that direction.