To bind an octavo or smaller book according to the specification given (III, page 307); first make all sections sound, and guard all plates or maps. Make end papers with zigzags. After the sections have been thoroughly pressed, the book will be ready for marking up and sewing. In marking up for sewing on tapes, two marks will be necessary for each tape. When there are several books of the same size to be sewn, they may be placed one above the other in the sewing press, and sewn on to the same tapes. It will be found that the volumes when sewn can easily be slid along the tapes, which must be long enough to provide sufficient for the slips of each. The split boards may be "made" of a thin black mill-board with a thicker straw-board. To "make" a pair of split boards the pieces of straw-and mill-board large enough to make the two are got out, and the straw-board well glued, except in the centre, which should previously be covered with a strip of thin mill-board or tin about four inches wide. The strip is then removed, and the thin black board laid on the glued straw-board and nipped in the press. When dry, the made board is cut down the centre, which will leave two boards glued together all over except for two inches on one side of each. The boards then are squared to the book in a mill-board machine. The back of the book is glued up, and in the ordinary way rounded and backed. The edges may be cut with a guillotine. The ends of the tapes are glued on the waste end paper, which should be cut off about an inch and a half from the back. The split boards are then opened and glued, and the waste end papers with slips attached are placed in them (see fig. 72), and the book nipped in the press. To form a "French joint" the boards should be kept about an eighth of an inch from the back of the book. The book is then ready for covering. The leather must not be pared too thin, as the French joint will give plenty of play and allow the use of much thicker leather than usual. If time and money can be spared, headbands can be worked, but they are not absolutely necessary, and a piece of string may be inserted into the turning of the leather at head and tail in the place of them. When the book is covered, a piece of string should be tied round the joints, and the whole given a nip in the press. The corners of the boards should be protected by small tips of vellum or parchment. The sides may be covered with good paper, which will wear quite as well as cloth, look better, and cost less.