Fig. 42: If a glass tube, _F_, stopped at one end, 3 feet long or over, be filled with mercury and the open end immersed in a vessel of mercury, _T_, the column of metal in the tube will sink until it attains a height, _M_, of about 30 inches, varying according to the condition of the atmosphere.

The space between the mercury column and the top of the tube will be a fairly good vacuum. This fact was noted many years ago, and the gradual evolution of the mercurial air-pump based on this result can be followed in the articles on the mercurial air-pump by Silvanus P. Thompson, read before the Society of Arts, England, some years ago.

Induction Coils, How to Make, Use, and Repair Them. — Part 46

Geissler, the first manufacturer of the "Geissler" or vacuum tube for electrical research, seeing the inconvenience of the above-described operation and the meagre results obtained, invented the pump called by his name (Fig. 43).

Induction Coils, How to Make, Use, and Repair Them. — Part 46

_F E_ is a stout glass tube some 3 feet long, having a bulb, _B_, at its upper extremity, and a rubber tube, _S_, attached to the curved end. A reservoir of mercury, _R_, connects with this rubber tube, and a special glass tap is fixed in the upper end of the glass tube at _E_, beyond which tap being the point of attachment for the object to be exhausted. The operation is as follows: On turning the tap a part of the way it allows a passage between the tube _F E_ and the atmosphere. The reservoir _R_ is then raised until the mercury flows into the bulb and up the tube to the tap. The tap is then turned a fraction, and the communication with the air is shut off and opened between the object to be exhausted and the tube _F E_. The reservoir is then lowered and the mercury falls, drawing down the air from the object into the tube. The tap is then turned as in the first place, and the reservoir _R_ raised, when the air drawn into the tube is forced out by the rising column of metal. This operation being repeated many times, withdraws nearly all the air from the object—in fact, makes a fairly good vacuum. This pump has been much modified from the simple form described.

Induction Coils, How to Make, Use, and Repair Them. — Part 46

The form of pump most used in the United States lamp factories is based on the application of the piston-like action of a quantity of mercury dropping down a tube. This is known as the Sprengel pump, after the inventor.