To enable us to practically experiment with and to fully demonstrate all the problems of lock, draw, drop, etc., we make quite a large hole in _C_ where the screws _b_ come. To explain, if the screws _b b_ were tapped directly into _C_, as they are shown at Fig. 95, we could only turn the disk _D_ on the screw _b_; but if we enlarge the screw hole in _C_ to three or four times the natural diameter, and then place the nut _e_ under _C_ to receive the screw _b_, we can then set the disks _D D'_ and pallets _B B'_ in almost any relation we choose to the escape wheel, and clamp the pallets fast and try the action. We show at Fig. 97 a view of the pallet _B'_, disk _D'_ and plate _C_ (seen in the direction of the arrow _c_) as shown in Fig. 95.

PRACTICAL LESSONS WITH FORK AND PALLET ACTION.

Watch and Clock Escapements — Part 73

It will be noticed in Fig. 99 that the hole _g_ for the pallet staff in the lever is oblong; this is to allow the lever to be shifted back and forth as relates to roller and fork action. We will not bother about this now, and only call attention to the capabilities of such adjustments when required. At the outset we will conceive the fork _F_ attached to the piece _E_ by two screws passing through the holes _h h_, Fig. 99. Such an arrangement will insure the fork and roller action keeping right if they are put right at first. Fig. 100 will do much to aid in conveying a clear impression to the reader.

Watch and Clock Escapements — Part 73

The idea of the adjustable features of our escapement model is to show the effects of setting the pallets wrong or having them of bad form. For illustration, we make use of a pallet with the angle too acute, as shown at _B'''_, Fig. 101. The problem in hand is to find out by mechanical experiments and tests the consequences of such a change. It is evident that the angular motion of the pallet staff will be increased, and that we shall have to open one of the banking pins to allow the engaging tooth to escape. To trace out _all_ the consequences of this one little change would require a considerable amount of study, and many drawings would have to be made to illustrate the effects which would naturally follow only one such slight change.

Watch and Clock Escapements — Part 73

Suppose, for illustration, we should make such a change in the pallet stone of the entrance pallet; we have increased the angle between the lines _k l_ by (say) one and a half degrees; by so doing we would increase the lock on the exit pallet to three degrees, provided we were working on a basis of one and a half degrees lock; and if we pushed back the exit pallet so as to have the proper degree of lock (one and a half) on it, the tooth which would next engage the entrance pallet would not lock at all, but would strike the pallet on the impulse instead of on the locking face. Again, such a change might cause the jewel pin to strike the horn of the fork, as indicated at the dotted line _m_, Fig. 99.