If Fig. 1 is made of cardboard, flange A must have the surface of the cardboard pared away, otherwise the joining will be clumsy. The dotted lines represent bends only in the case of paper, but half cuts in the case of cardboard.
With regard to the size of the flange, this will depend upon the strength of the adhesive used and the stiffness of the material. Generally speaking, the larger the flange the better, for a narrow flange tends to turn up and must be held down longer than a wide one.
A good general rule to remember when joining two pieces of material is this--that it is always the thinner of the two that is to be pasted or glued. This must be borne in mind when using the second method of joining cardboard or paper edges.
(2) Using paper hinges. The hinge should extend the whole length of the edges that come together, as in Fig. 2, where pieces of cardboard A and B are joined by the hinge _a b c d e f_. Before pasting the hinge must be folded along _b e_, care being taken that _b e_ is at right angles to _a c_ and _d f_.
The sides, bottom, and roof of the Noah's Ark are joined together by paper hinges (Chapter X).
(3) Wherever it is necessary to join curved edges, the flange must be cut as in Fig. 3_a_, flange _a b c d_. Fig. 3_b_ shows paper curved and flanges bent down ready for pasting.
This is the method used for fastening on paper funnels, the bottom of the paper mug (Fig. 57, Chapter IV), etc.
=The Making and Fixing of Wheels.= If it is desired to attach movable wheels to any of the toys described in the following chapters (in the early chapters for greater simplicity the wheels are gummed to sides of carts, or to matches, etc.), the following methods are suggested.
(1) The wheels can be rigidly fixed to the axle--that is, a match end is pushed tight into the cardboard wheel and the axle is free to turn in loose bearings, as in Fig. 4, fixed under the cart or other vehicle or to the sides. These bearings can be cut from cardboard or cartridge paper.
In Fig. 4 the paper is bent at a right angle along the dotted line, and the rectangular portion is gummed under the cart. If the rectangular portion is gummed to the side of the cart no bend is needed. The parts of the match sticks that pass through the holes must be rounded with sand-paper so that they will turn easily in the holes.