Backing and rounding is the most important work as far as regards the appearance of the book when finished; it must be done with the greatest exactitude and requires much practice. Although it is hardly perceptible, yet the great difficulty lies in the book itself being so very easily shifted.

When the book is placed in the press without a fault it is screwed up as tightly as possible with the screw key, and through this the grooves already project over the edges of the backing boards; but a sharp groove can only be obtained by the help of the hammer.

Practical Bookbinding — Part 40

The hammer, however, must not be used blindly on the back, but by lightly knocking, blow by blow, the first and last 4-6 sheets must be brought over the edges of the boards. This done, the whole of the back is well pasted, and after remaining thus a short time it is then rubbed with the point of the hammer along the sheets until all superfluous glue is soaked and scraped off. With a handful of paper cuttings the back is rubbed smooth and clean. The use of a toothed _cachir_ iron is strictly forbidden, but the round side of this tool may be used instead of the hammer.

Practical Bookbinding — Part 40

Fig. 40--Backing machine for small shops.

Practical Bookbinding — Part 40

For backing, we have also a useful machine--the backing machine. For small shops it is made for clamping only, and the making of the groove is done with the ordinary hammer. For large shops this machine has a roller going right across the back which forms the groove down each side.

Fig. 41--Backing machine for large shops.

Valuable books are either trimmed at the front and at once backed or they may be backed before trimming. This is generally done with bulky books, as they are liable to throw out a section, and this danger is lessened by backing first. The work of backing remains the same. If the fore-edge has already been trimmed, care must be taken that the grooves do not suffer during trimming after backing. One way of effecting this is to lay the book on a special cutting board with the edge up to the groove, or by making use of the arrangement on the clamp already described, and adjusting the groove of the book to the blocks fixed on the clamp.

Should the fore-edge not have been cut, the book must again be knocked straight after backing; to do this a strong cord is tied round the book about 1-1/2 cm. from the back, the book is then laid upon a firm bed, and the back again knocked straight; this work is called "tying up."