For paring the edge of paper for mending or guarding, take a very sharp knife, and holding the blade at right angles to the covering-board, draw the edge once or twice along it from left to right. This should turn up enough of the edge to form a "burr," which causes the knife to cut while being held almost flat on the paper. The plate or paper should be laid face downwards on the glass with the edge to be pared away from the workman, the knife held in the right hand, with the burr downwards. The angle at which to hold the knife will depend on its shape and on the thickness and character of the paper to be pared, and can only be learned by practice. If the knife is in order, and is held at the proper angle, the shaving removed from a straight edge of paper should come off in a long spiral. If the knife is not in proper order, the paper may be badly jagged or creased.
Place a piece of well-sized paper in a pan of warm water, then lay the mounted India proof, face downwards, upon it and leave it to soak until the proof floats off. Then carefully take out the old mount, and the India proof can be readily removed from the water on the under paper, and dried between sheets of blotting-paper.
Very thin paper, such as that of some "India" proofs, may be safely mounted as follows:--The mount, ready for use, is laid on a pad of blotting-paper. The thin paper to be mounted is laid face downwards on a piece of glass and very carefully pasted with thin, white paste. Any paste on the glass beyond the edges of the paper is carefully wiped off with a clean cloth. The glass may then be turned over, and the pasted plate laid on the mount, its exact position being seen through the glass.
It is sometimes desirable to split pieces of paper when the matter on one side only is needed, or when the matter printed on each side is to be used in different places. The paper to be split should be well pasted on both sides with a thickish paste, and fine linen or jaconet placed on each side. It is then nipped in the press to make the linen stick all over, and left to dry.
If the two pieces of jaconet are carefully pulled apart when dry, half the paper should be attached to each, unless at any point the paste has failed to stick, when the paper will tear. The jaconet and paper attached must be put into warm water until the split paper floats off.