In all soundly-constructed lever escapements the safety action is only called into use in exceptional cases, and if the watch was lying still would theoretically never be required. Where fork and pallets are poised on their arbor, pocket motion (except torsional) should but very little affect the fork and pallet action of a watch, and torsional motion is something seldom brought to act on a watch to an extent to make it worthy of much consideration. In the double-roller action which we shall consider, we shall adopt three-fifths of the pitch diameter of the jewel-pin action as the proper size. Not but what the proportions given by Grossmann will do good service; but we adopt the proportions named because it enables us to use a light fork, and still the friction of the guard point on the roller is but little more than where a guard roller of half the diameter of the acting roller is employed.
The fork action we shall consider at present is ten degrees, but subsequently we shall consider a double-roller action in which the fork and pallet action is reduced to eight degrees. We shall conceive the play between the guard point and the safety roller as one degree, which will leave half a degree of lock remaining in action on the engaged pallet.
THEORETICAL ACTION OF DOUBLE ROLLER CONSIDERED.
In the drawing at Fig. 81 we show a diagram of the action of the double-roller escapement. The small circle at _A_ represents the center of the pallet staff, and the one at _B_ the center of the balance staff. The radial lines _A d_ and _A d'_ represent the arc of angular motion of fork action. The circle _b b_ represents the pitch circle of the jewel pin, and the circle at _c c_ the periphery of the guard or safety roller. The points established on the circle _c c_ by intersection of the radial lines _A d_ and _A d'_ we will denominate the points _h_ and _h'_. It is at these points the end of the guard point of the fork will terminate. In construction, or in delineating for construction, we show the guard enough short of the points _h h'_ to allow the fork an angular motion of one degree, from _A_ as a center, before said point would come in contact with the safety roller.
We draw through the points _h h'_, from _B_ as a center, the radial lines _B g_ and _B g'_. We measure this angle by sweeping the short arc _i_ with any of the radii we have used for arc measurement in former delineations, and find it to be a trifle over sixty degrees. To give ourselves a practical object lesson, let us imagine that a real guard point rests on the circle _c_ at _h_. Suppose we make a notch in the guard roller represented by the circle _c_, to admit such imaginary guard point, and then commence to revolve the circle _c_ in the direction of the arrow _j_, letting the guard point rest constantly in such notch. When the notch _n_ in _c_ has been carried through thirty degrees of arc, counting from _B_ as a center, the guard point, as relates to _A_ as a center, would only have passed through an arc of five degrees. We show such a guard point and notch at _o n_. In fact, if a jewel pin was set to engage the fork on the pitch circle _b a_, the escapement would lock. To obviate such lock we widen the notch _n_ to the extent indicated by the dotted lines _n'_, allowing the guard point to fall back, so to speak, into the notch _n_, which really represents the passing hollow. It is not to be understood that the extended notch at _n_ is correctly drawn as regards position, because when the guard point was on the line _A f_ the point _o_ would be in the center of the extended notch, or passing hollow. We shall next give the details of drawing the double roller, but before doing so we deemed it important to explain the action of such guard points more fully than has been done heretofore.