[276] MASPERO, _Les Peintures des Tombeaux Égyptiens et la Mosaïque de Palestrine_, p. 82 (_Gazette Archéologique_, 1879).

[Illustration: FIG. 239.--Quadruped with the head of a bird. From Champollion, pl. 428 _bis_.]

A History of Art in Ancient Egypt, Vol. II (of 2) — Part 165

Work in low relief held such an important place in the affections of the Egyptian sculptor that we must study its processes in some detail.

A History of Art in Ancient Egypt, Vol. II (of 2) — Part 165

In the first place, it was almost invariably painted. Those bas-reliefs which show no trace of colour may be looked upon as unfinished.

A History of Art in Ancient Egypt, Vol. II (of 2) — Part 165

Secondly, the depth of the relief varied as much as it could, from the almost detached figures of the Osiride piers to the delicate salience of the carvings upon the steles and tomb-walls. A few works in very high relief have been found in the mastabas (Fig. 120, Vol. I.),[277] but they are quite exceptional; the depth is usually from two to three millimetres. It is the same with the Theban tombs. It is only in the life-size figures that the relief becomes as much as a centimetre, or a centimetre and a half in depth; articulations, the borders of drapery, and the bounding lines of the contour, are indicated with much less salience.

[277] See also LEPSIUS, _Denkmæler_, part ii. pl. 11, and a tomb at El Kab (_Eilithyia_). MARIETTE (_Voyage dans la Haute-Égypte_, plate 6 and page 37) cites, as a curious example of a bolder relief than usual, the scenes sculptured upon the tomb of Sabou, especially the picture showing the servants of the defunct carrying a gazelle upon their shoulders.

The processes used in Egyptian reliefs were three in number, one of those three, at least, being almost unknown elsewhere.

The commonest of the three is the same as that in favour with the Greeks, by which the figures are left standing out from a smooth bed, which is sometimes slightly hollowed in the neighbourhood of their contours. When limestone was used, this method was almost always preferred, as that material allowed the beds to be dressed without any difficulty.

Sometimes, on the other hand, the figure is modelled in relief in a sunk hollow, which is from half an inch to an inch and a half deep (Fig. 240). This method of proceeding, which is peculiar to Egypt, was doubtless suggested by the desire to protect the image as much as possible. For this purpose it was singularly efficient, the high "bed" of the relief guarding it both from accidental injury, and from the effects of weather and time. It had one disadvantage, however, in the confusing shadows which obscured a part of the modelling. This process was used, as a rule, for the carvings on granite and basalt sarcophagi (Fig. 195, Vol. I.). It would have cost too much time and labour to have sunk and polished the surrounding surfaces. This method, when once taken up, was extended to limestone, and thus we find, among those objects in the Louvre which were discovered in the Serapeum, a stele of extremely delicate workmanship, representing Amasis in adoration before an apis. The head of Amasis is damaged, and we have preferred to give as a specimen the fine head of Rameses II., chiselled in a slab of limestone, which is also in the Louvre (Fig. 240).