Sometimes a difficult part of a puncture on the road is its location. After examining the tire and noting the likely places, apply saliva at these spots, and when the right one is found, bubbles will be noticed.
The permanent repair of a double-tube tire is to patch the inner one. Let the air out, and if the tire is "cemented" pull it off, and, if the "clincher," spring off, being careful in pushing the valve through the hole in the rim. If it is the "clincher" pattern the inner tube may be readily removed, but if a "cemented" tire, it is a trifle more difficult. In the latter there is a slit about eight inches long in the outer tube, where the valve comes through, which is held together with lacing. Cut this lacing, and the two ends of the inner tube will be seen to come together here. Fasten a string to one end, and catching hold of the other end, pull the tube out, being careful to leave the string in the casing. When removed inflate tightly, and grasping firmly a section between your hands about a foot long, immerse in water and stretch to the utmost; and if the puncture is in this section this will sufficiently enlarge it to permit the free escape of bubbles. Continue this way throughout the whole tube, and when the puncture is located, bite a little piece of the rubber out from around it so that it may be more readily found; let the air out, and cut a piece of rubber to fit over the hole, covering the edges of the puncture and this piece with a rubber cement made for this purpose; and when a trifle dry, place the patch on and put a weight on top. Inflate and test in water for leaks, and if all is right let the air out and fasten one end to the string, which was carried into the outer tube on the removal of the inner one, and by this haul it in place again, lacing up the slot with string. Inflate again, and, after covering the rim of the wheel with cement, place it on and let it dry, revolving the wheel with the rim and tire in water so as to make the cement set.
The method of making permanent repairs in a hose-pipe or single-tube tire is simple--namely, by plugging. A rubber plug with a head like a rivet is covered with cement and inserted in the puncture, head within the tire, and when it sets, the projecting part on the exterior is trimmed off evenly.