All of the above will have to come from a greenhouse material supply company, and prices given do not include freight charges. The following items may probably be bought more economically in your immediate vicinity, and the prices will vary in different sections of the country:--

Total of items listed above $46.50 240 ft. rough 1-in. boards 7.50 6 posts, 4 in. thick, 6 ft. long, planed on one side} 3.00 2 posts. 4 in. thick, 8 ft. long, planed on one side} 1000 shingles 4.00 ------ Total cost of materials $61.00 Estimate of labor 20.00 ------ Total cost of greenhouse $81.00

Gardening Indoors and Under Glass — Part 82

Level off a place about 22 x 12 feet, and set in the posts as indicated in the plan on page 158, taking care to get the lines for the ends of the house perfectly square with the wall, and exact in length. This is best done by laying out your lines first with stout string, and making your measurements accurately on these. Then put in the posts for sides and ends, setting these about three feet into the ground, or, better still, in concrete. Put in the two corner posts, which should be square first. Next saw off all posts level at the proper height, and put in place the 2 x 4 in. eaves plate on top of these and the 2 x 6 in. sill just far enough below to take a 16 x 24 in. light of glass, with its upper edge snug in the groove in lower side of plate, as shown in detail of section on page 159. Fit the 2 x 6 in. sill about the posts so that the mortice on same will just clear the outside of posts. Then put on the siding on sides and ends--first a layer of rough inch-boards, running vertically, a layer, single or double, of tar paper, and a second layer of boards, laid horizontally, covering on the outside with shingles, clapboards or roofing paper. The five 7 ft. x 1-1/4 in. pipe posts may now be placed loose in their holes, and a walk dug out of sufficient depth to allow passage through the middle of the house. Rough boards nailed to stakes driven into the ground, will hold the earth sides of this in place.

Gardening Indoors and Under Glass — Part 82

Next, after having it sawed in two vertically (thus making 20 ft), screw the ridge securely to side of house at proper height, giving a thick coat of white lead at top to insure a tight joint with house. Now put one of the end bars in place, taking care to get it exactly at right angles with ridge, and then lay down the sash-bars, enough more than 16 in. apart to allow the glass to slip into place readily. Take a light of glass and try it between every fourth or fifth bar put into position, _at both ridge and eave_, as this is much easier than trying to remedy an error when half the glass is laid. Use "finishing" nails for securing the sash-bars, as they are easily split. Next, with chalk line mark the middle of the roof sash-bars, and secure to them the one-inch pipe purlin, which will then be ready to fasten to the uprights already in place. Next, make concrete by mixing two parts Portland cement, two of sand and four of gravel or crushed stone with sufficient water to make a mixture that will pour like thick mud, and put the iron pipe posts in their permanent positions, seeing that the purlin is level and the posts upright. (If necessary, the purlin can be weighted down until the concrete sets.) Then put into place the ventilators, glazed, and the headers for the same--short pieces of wood, cut to go in between the sash-bars,--and fit these up snugly against the lower edge of the ventilator sash.

Gardening Indoors and Under Glass — Part 82