A few days later, a girl with a white but radiantly happy face is resting in a cane armchair, her feet supported by a footstool, in the garden of a pretty country house at Fridorf. The sunshine is hot, but she is shaded from it by a trellis work of young-leaved creepers overhead. Lilacs and laburnum trees bloom abundantly around. The lawn before her is smooth and green, and beyond is the sea.
"How wonderful God's love is!" the girl says, presently, reaching out her hand to an old woman with a peaceful face who shortly joins her, and who clasps and retains the hand with an answering look more eloquent than speech.

[1] Sesame and Lilies. By John Ruskin LL.D. 1. Of Kings' Treasuries. 2. Of Queens' Gardens.

Modelling in clay is a very agreeable change in one's artistic occupation, for it is quite unlike other branches of art, and calls into play a different set of faculties for its performance. It needs a greater amount of "hand cunning" than does painting, and is in that sense akin to wood carving, to which delightful craft it is, indeed, almost indispensable, and, I might add, part of the necessary training one has to undergo to become a carver in wood. And as on another occasion I am going to write a few hints on wood carving, the present article may be taken as a prelude to the one on that subject.

The materials necessary to try one's hand at modelling are very inexpensive. The clay is the most essential thing, and this can be purchased at one or two artists' colourmen, or, better still, at any pottery. I have had clay sent me from the potteries in Staffordshire, and those of my readers who live near a pottery would have no difficulty in supplying themselves with clay. The clay used for flower-pots does for coarse work, but is not sufficiently carefully prepared for fine work. It burns a rich red colour, and is, of course, terra-cotta. The clay used in making the terra-cotta plaques and vases is what you require for fine work. There are two or three firms who supply London shops with terra-cotta vases, etc., and I have no doubt that clay might be purchased of them.
The clay used in making tiles does for modelling, but perhaps the best is that which burns a cream colour. It is a dull grey colour, rather dark before it is fired, and it should be noticed that it is difficult to tell the colour clay will burn by its appearance when unbaked. Thus a grey clay may burn a rich red or pale cream. The qualities necessary in clay for modelling are plasticity, which enables it to be worked without falling to pieces, and fineness--a perfect freedom from grit, small stones, and other impurities. It should be quite soft to the touch, and when pressed and kneaded should feel smooth and silky. Old clay is more plastic as well as being tougher than new, and in potteries clay is often kept a considerable time before it is used. The clay should not be allowed to dry when it is not in use, and to prevent this it must be wrapped in wet flannel. Should it dry quite hard, there is nothing to do but to put it into a vessel and pour water on it, allowing it to stand until the clay becomes soft. Some of the moisture must then be allowed to evaporate, otherwise it is too soft for use. This is another point to be observed in clay used for modelling. It must not be too damp. If it sticks to the fingers it is too wet, and if it resists the pressure of the fingers, too dry. The state between stickiness and stubbornness is what is wanted.





