Nothing more than will be found in an ordinary dark-room will be found necessary in bromide printing by contact, unless it be some arrangement for determining readily the distance of the negative from the source of light. For this purpose and with an oil-lamp, use a board a foot wide and about three feet long placed on the developing bench against the base of the dark-room lamp. It should be marked with black lines six inches apart. See Fig. 2.

Greater uniformity in lighting will be gained if a piece of white cardboard be placed immediately behind the flame. Some lamps have reflectors, in which case the card is unnecessary, provided that they reflect the light uniformly; otherwise such reflectors are worse than useless.

Bromide Printing and Enlarging — Part 7

Having arranged the needful apparatus to our satisfaction, the last preparatory step before manipulation is the making up of a developer. Almost any of the modern developers (pyro excepted) will give good results with bromide paper. In every package of paper will be found the developers advised by the manufacturer of the paper used. Invariably there is among these a formula for ferrous oxalate developer. This is probably the best of all developers for pure black tones, but I cannot advise the novice to take it up in the early stages of his work with bromide paper.

Bromide Printing and Enlarging — Part 7

When this developer is used an acid clearing bath is necessary, and this invites complications which may be disastrous to the prints. When experience has been gained, and a large number of prints are to be made at one time, it will be found advantageous as working longer with greater efficiency and more uniformity than some of the other developers. It is troublesome to prepare and does not keep well, apart from which there is the disadvantage that it does not permit of control in development in as large a measure as other developers.

Bromide Printing and Enlarging — Part 7

A reliable metol and hydroquinone formula is as follows: Thoroughly dissolve metol, 1/4 ounce; hydroquinone, 1/4 ounce; in water, 80 ounces; add sulphite of soda (cryst.), 4 ounces; and carbonate of soda (cryst.), 2-1/2 ounces. Bottled in 4-ounce vials and well corked, this developer retains its working power indefinitely. For normal exposures I take 2 ounces of the above and add to it 2 ounces of water. This will suffice for the development of three 8 × 10 sheets of paper, or their equivalent in smaller sheets. It is not wise to attempt to make it do more, as greenish tones will result. For the same reason, contrary to common opinion, I do not advise the addition of potassium bromide to the developer. It does not improve the developer, and may do harm.