In mounting large birds, the sizes of the wires I have used were as follows: Great horned owl, No. 8 or 9; bald eagle, No. 7 or 8; peacock, No. 7; great blue heron, No. 6; sandhill crane, No. 5.

An ostrich or emu requires a manikin constructed on the same principles as that built for the tiger, except that each leg-rod should have two iron squares instead of one. The upper extremity of the leg-rod is clamped tightly to one square, with two nuts, as usual; but in addition to this there should be a second square with a hole in its short arm large enough for the smooth rod to slip through, and this should be screwed to the body-board as low down as the anatomy of the bird will allow. The object of this second iron is to prevent the bipedal specimen from swaying and leaning over, as it would otherwise be very apt to do.

Taxidermy and Zoological Collecting — Part 152

Inasmuch as the legs of an ostrich or emu always require to be cut open and completely skinned, the manikin method is perfectly adapted to their wants. If the skin is so shrunken that it requires vigorous stretching, its body must be stuffed with straw after the neck and legs have been made and joined to a centre-board, precisely as directed for long-haired mammals above medium size. I may also remark in this connection that I have seen both the complete skin and skeleton of a large ostrich preserved and mounted to stand side by side, but I pitied the operator when he had to make a full set of bones for the legs and feet, and a wooden skull with the horny shell of the beak fastened upon it. At one stage of the proceedings the outlook for the skin seemed anything but promising, and on the whole I would not advise anyone save an expert to attempt a similar task.

Taxidermy and Zoological Collecting — Part 152

MOUNTING BIRDS WITH WINGS SPREAD.--In the first place, each wing must have a wire large enough to adequately support it. This should be straight, bright, well-oiled, and filed sharp at both ends. One end is to be inserted inside the skin, passed along next to the wing-bones as far as the carpal joint, from thence it is forced on as far as possible between the skin and the under surface of the metacarpal bones until it emerges from the feathers not far from the end of the fleshy portion of the wing. The wing must be so straight that the wire can be slipped through it freely backward and forward. It must next be passed through the artificial body at the point where the upper end of the humerus is attached to the coracoid in the complete skeleton, and very firmly clinched in the same way as described for the leg-wires. Then lay the bird upon its back, place the wing exactly in position, bend the wing-wires so they will fit snugly against the wing-bones, and tie them firmly down. After that, the middle joint of each wing is to be poisoned, stuffed with fine tow, and sewn up neatly. Of course the wings can not be given their correct elevation and pose until the bird is placed firmly upon its temporary perch, unless it is to be represented as flying.

Taxidermy and Zoological Collecting — Part 152