------------------+------------------------------------------ SYMBOLS | DISTANCE IN CM. ACCORDING TO | TRAVELED BY THE OIL AT THE END TABLE III. | OF EACH DAY. ------------------+----+----+----+----+----+----+-----+------ DAYS. | 0.3| 1.3| 2.3| 3.3| 4.3| 5.3| 6.3 | 7.3 ------------------+----+----+----+----+----+----+-----+------ E. K. w. |14 |23 |26.5|28.5|29.5|31.5|32.5 |33 W. F. N. w. |12.5|20 |26.5|29 |31 |32.5|33.5 |34 W. C. w. |19 |24 |26.5|28 |29 |30.5|32 |33 B. & K. w. |14 |17.5|25 |27 |29.5|31.5|33 |33.5 S. B. & Co. w. c. |10 |20 |26 |26.5|27 |27.5|28 |28.5 C. L. Co. w. |29 |38 |40.5|42.5|43 |43.5|Stat.|43.5 C. L. Co. No. 1. |17.5|23 |27 |28 |29 |30 |31 |32 Glyc. |17.5|23 |28 |30 |32 |34 |35 |35.2 Alb. f. |15 |20 |29 |33 |35 |37 |38 |38.5 ------------------+----+----+----+----+----+----+-----+------

The author once heard a watchmaker say to a customer, when the latter called for a clock which had been left for repairs, "I have cleaned your clock thoroughly; and, as you are a good customer, I made as good a job of it as I could. _I even oiled it with watch oil._" This watchmaker evidently _thought_ he was right. It is hardly necessary to mention that a stock of oils of different viscosity should be kept on hand and intelligently used; the different bearings in any time keeping mechanism requiring oils of different viscosity. It is not to be supposed that the author means _each_ bearing in a watch is to have a separate oil applied; but a distinction should be made between the light and heavy pressures.

Friction, Lubrication and the Lubricants in Horology — Part 41

~82. The Effect Of Heat On Oils~ is very marked in all cases; some oils being much more subject to change than others, in viscosity and other properties, under the influence of an increase of temperature.

Friction, Lubrication and the Lubricants in Horology — Part 41

The lubricating power of an oil is decreased, while its tendency to spread is increased, with a rise of temperature. In order to ascertain the relative values of various oils in this respect the writer used a plate of glass 28 cm. x 40 cm., placed it flat on a table, and, depositing one drop of each oil near one of its longer edges, allowed it to remain in a temperature of 21° C. (= 70° F.) for 30 minutes. At the end of this time the glass plate was placed in a vertical position, with its edge near which the drops of oil had been deposited uppermost and horizontal. The time required by each oil to run down to the bottom, a distance of 25 cm., was noted. The width of the track, at a point 3 cm. from the location of the drop at the start, was measured when the oil had passed that point, and again measured _at the same point_ when the oil had reached the bottom.

Friction, Lubrication and the Lubricants in Horology — Part 41