It requires four irons to fasten the legs to the centre board, one for each leg, and to make a set for an animal the size of a large mountain sheep ram, proceed as follows:
Procure four pieces of flat bar iron, 1/4 of an inch thick, 1-1/4 or 1-1/2 inch wide, and 9 inches long. At a point 3-1/2 inches from one end, bend each iron at a perfect right angle, which, of course, can only be done by heating it. Now heat the short arm red hot, clamp the end of it in a vise, and make a twist of exactly a quarter of a turn in the short arm, as close up to the angle as you can. This will make the end of the short arm stand out in a horizontal plane against the side of the body board.
At the end of the short arm, with its centre exactly 3 inches from the inner face of the long arm, drill or punch a hole of the right size to receive the threaded end of the leg iron, but no larger. (For our _Ovis montana_ ram it should be half an inch in diameter.) File off the sharp corners of this end.
[Illustration: FIG. 31.--An Iron Square.]
At a point about 1-1/4 inch from the inner angle of the square, and in the long arm, drill a hole about 7/16 or 1/2 an inch in diameter, for a stout bolt to pass through. Between that and the end of the long arm, drill (or punch) two screw-holes, and countersink them. That is all there is to the making of the square, and the accompanying cut (Fig. 31) accurately represents it. Each pair of squares is put on with a single square-headed bolt, the length of which varies according to the thickness of the body board. For our mountain ram, the bolts should be 3/8 of an inch in diameter, and about 2-1/2 inches long.
It is useless and unnecessary for me to attempt to describe the different sizes of squares necessary for animals of various sizes, for circumstances must be the instructor in that. I will remark, however, that for a large bison or moose, where the finished specimen will weigh perhaps 600 or 700 pounds, and the strain on the irons is very considerable, I have found it necessary to make squares of flat iron 3/8 or 7/16 of an inch thick by 1-3/4 inch wide.
_Caution.--Do not make, the short, or outer arm, too long._ If too long, and the hole once drilled, you will hardly be able to make it shorter; but if too short, it can easily be made longer by putting a piece of board between the long arm of the square and the body board. The length of the outer arm of the squares for the hind legs is gauged by the width of the pelvis. The measurement to be taken is the distance between the centres of the two femora when both are in their natural positions in the skeleton, and with this distance once ascertained it is easy to deduct the thickness of the centre board, and calculate how long each outer arm shall be. The distance between the heads of the two humeri is practically the same as the distance between the femora.