Some illustrations of combined tannages are the following: Alum-chrome tan. The skins are tanned by the regular alum process, then the constituents of the chrome tan are dissolved directly in the same bath, and the chrome tan is effected as usual. Chrome-formaldehyde tan. To the regular chrome tan solution is added 1/2 lb. of formaldehyde for every 10 gallons of chrome liquor. The rest of the process is as ordinarily.
In practise, the vegetable tanning matters are not used for furs, although in some special instances gambier cutch may be employed occasionally with some other tan. However, many of these tannins also have dyeing properties, and are used in dyeing the furs. In this connection it must be mentioned that furs dyed with these materials also receive a vegetable tan, which improves the quality of the leather to a considerable extent.
Comparison of The Various Tanning Methods
In choosing a method for tanning any particular kind of fur, several factors must be considered. The nature of the pelt, insofar as it is weak or strong; the time, labor and cost of materials required by the tanning process; the effect on the leather of the different dyes and chemicals used in dyeing, if the skin is to be dyed, are a few of the points requiring attention and consideration.
For furs which are only to be dressed, a simple tan like the pickle will suffice in most cases. Special instances, such as the rabbit and mole already mentioned, and a few other furs are tanned by the alum method. The pickle is undoubtedly the cheapest and simplest method of tanning skins, and yields a soft, white leather which is permanent as long as it is kept dry. If it is put into water, about 25% of the salt contained within the pelt dissolves out, and the acid present swells up the tissues. If the skin is dried in this condition, it will come out hard and brittle, tending to crack very easily. By treating the leather before drying with a strong salt solution, a good deal of the extracted salt will be replaced, and on drying and stretching, it will work out soft. Skins tanned by the "Schrot-beize" are affected by water in quite the same manner as the pickled skins.
The alum tan gives a leather similar to that produced by the pickle, but with the advantage that the skins possess greater stretch and flexibility. In its resistance to water, the alum-tanned pelt is quite as susceptible as the other. As a general rule, the skin absorbs about 6% of its weight of alum from the tanning solution, but gives up three-quarters of this when it is soaked in water, producing on drying, a hard, stiff leather. The chrome tan is especially impervious to water, easily resisting temperatures of 80° C., and even boiling water. It is employed to only a limited extent on account of the special effort and care required to obtain satisfactory results, also because the pelt acquires a pale blue-green color which is not desired on dressed skins. The chamois tan, and some of the combinations of the formaldehyde tan with the other methods, give very soft, flexible leathers which possess a sufficiently great resistance to the effects of water and heat.