The AN/FPS-117 is an L-band active electronically scanned array (AESA) 3-dimensional air search radar first produced by GE Aerospace in 1980 and now part of Lockheed Martin. The system offers instrumented detection at ranges on the order of and has a wide variety of interference and clutter rejection systems.

The system was originally developed as part of the "Seek Igloo/Seek Frost" effort to replace the older radar systems of the DEW line with designs that could be operated remotely and require much less maintenance as part of DEW's replacement, the American-Canadian North Warning System (NWS). Implementation of the NWS resulted in a reduction in operations and maintenance spending by up to 50% compared to previous systems.

AN/FPS-117

GE made a number of modifications to the basic design to better tailor it to different roles. To fill a need for the US Marine Corps, GE developed the transportable AN/TPS-59, and later combined design elements to produce the smaller AN/TPS-77 which is even more mobile, requiring only one prime mover in some deployment scenarios. FPS-117s, modified with input from Siemens for German service are known as the RRP-117, while the TPS-77s in service with the RAF are known as the AMES Type 92. An even smaller version was introduced by Lockheed Martin as the TPS-77 MRR.

AN/FPS-117

Development

Development of array antennas

A key problem for radar systems of the 1950s was the introduction of the carcinotron, a microwave-producing tube that could be rapidly tuned across a wide bandwidth. Scanning rapidly, it appeared to be a constant radiator across an entire band, creating a powerful form of barrage jamming. To overcome this form of jamming, radars of the era were extremely powerful; the AMES Type 85 of the Royal Air Force sent out pulses of at least 8 MW in an effort to overcome the jammer's signal. Systems of such power have a number of practical downsides; cooling such a system is not a small endeavour, and the physical size of the transmitter tubes precludes it from being even partially mobile.

AN/FPS-117

During the 1950s, variations on the array antenna were being actively explored by many designers. In these systems, a large number of small antennas work together to produce a single output beam. By introducing small delays, using devices known as phase shifters, the output of the beam could be steered electronically. This offered the possibility of rapid scanning without mechanical movement, which made the systems much easier to produce in a mobile form. The original Marconi Martello offered the same detection capability as the Type 85 from a "transportable" design using six prime movers.

Most early phased array systems used a single transmitter tube, but experiments where every antenna elements had their own transmitter, were underway. In these "active array" systems, one could use the individual transmitters to produce multiple beams pointing in different directions, which would allow, for instance, some beams to continually track targets while others continued to scan the sky. However, such systems were extremely expensive until the introduction of solid-state transmitter modules.

While solid-state systems reduced the price of an antenna array, they did not offer nearly the same power output, even in aggregate. In previous designs, radars typically sent out extremely powerful but very short pulses of signal. The signals were short in time in order to provide reasonable range resolution. Given that the solid-state systems could not reach these power levels, longer pulses would have to be used so the total energy reflected from the target was similar. To regain range resolution, the relatively new technique of pulse compression was widely introduced.

By the late 1970s all of these technologies were maturing, and the possibility of fully active radars at reasonable price points emerged for the first time.

Seek Igloo

The DEW line system across northern Canada and Alaska was built in the 1950s using 1950s-era AN/FPS-19 radars. These used two 500 kW magnetrons on huge always-turning parabolic antenna systems and rooms filled with tube-based electronics to drive them. The systems required constant maintenance by on-site staff and was enormously expensive to operate.

Desiring a much simpler, and less-costly, system, in 1977 the Rome Air Development Center (RADC) began the "Seek Igloo" project to find a replacement for the FPS-19 that would require less power and would run for extended times without maintenance. In 1980, General Electric won the contest with their GE-592 design, and the final design was accepted by RADC on 30 September 1983 and passed acceptance tests that year.