ITU-T Y.1564 is an Ethernet service activation test methodology, which is the new ITU-T standard for turning up, installing and troubleshooting Ethernet-based services. It is the only standard test methodology that allows for complete validation of Ethernet service-level agreements (SLAs) in a single test.

Purposes

ITU-T Y.1564 is designed to serve as a network service level agreement (SLA) validation tool, ensuring that a service meets its guaranteed performance settings in a controlled test time, to ensure that all services carried by the network meet their SLA objectives at their maximum committed rate, and to perform medium- and long-term service testing, confirming that network elements can properly carry all services while under stress during a soaking period.

Y.1564

ITU-T Y.1564 defines an out-of-service test methodology to assess the proper configuration and performance of an Ethernet service prior to customer notification and delivery. The test methodology applies to point-to-point and point-to-multipoint connectivity in the Ethernet layer and to the network portions that provide, or contribute to, the provisioning of such services. This recommendation does not define Ethernet network architectures or services, but rather defines a methodology to test Ethernet-based services at the service activation stage.

Y.1564

Existing test methodologies: RFC 2544

The Internet Engineering Task Force RFC 2544 is a benchmarking methodology for network interconnect devices. This request for Comments (RFC) was created in 1999 as a methodology to benchmark network devices such as hubs, switches and routers as well as to provide accurate and comparable values for comparison and benchmarking.

Y.1564

RFC 2544 provides engineers and network technicians with a common language and results format. The RFC 2544 describes six subtests: Throughput: Measures the maximum rate at which none of the offered frames are dropped by the device/system under test (DUT/SUT). This measurement translates into the available bandwidth of the Ethernet virtual connection. Back-to-back or burstability: Measures the longest burst of frames at maximum throughput or minimum legal separation between frames that the device or network under test will handle without any loss of frames. This measurement is a good indication of the buffering capacity of a DUT. Frame loss: Defines the percentage of frames that should have been forwarded by a network device under steady state (constant) loads that were not forwarded due to lack of resources. This measurement can be used for reporting the performance of a network device in an overloaded state, as it can be a useful indication of how a device would perform under pathological network conditions such as broadcast storms. Latency: Measures the round-trip time taken by a test frame to travel through a network device or across the network and back to the test port. Latency is the time interval that begins when the last bit of the input frame reaches the input port and ends when the first bit of the output frame is seen on the output port. It is the time taken by a bit to go through the network and back. Latency variability can be a problem. With protocols like voice over Internet protocol (VoIP), a variable or long latency can cause degradation in voice quality. System reset: Measures the speed at which a DUT recovers from a hardware or software reset. This subtest is performed by measuring the interruption of a continuous stream of frames during the reset process. System recovery: Measures the speed at which a DUT recovers from an overload or oversubscription condition. This subtest is performed by temporarily oversubscribing the device under test and then reducing the throughput at normal or low load while measuring frame delay in these two conditions. The difference between delay at overloaded condition and the delay and low load conditions represent the recovery time.