The Saffir–Simpson hurricane wind scale (SSHWS) classifies hurricanes—which in the Western Hemisphere are tropical cyclones that exceed the intensities of tropical depressions and tropical storms—into five categories distinguished by the intensities of their sustained winds. This measuring system was formerly known as the Saffir–Simpson hurricane scale, or SSHS.

To be classified as a hurricane, a tropical cyclone must have one-minute-average maximum sustained winds at 10 m above the surface of at least 74 mph (64 kn, 119 km/h; Category 1). The highest classification in the scale, Category 5, consists of storms with sustained winds of at least 157 mph (137 kn, 252 km/h). The classifications can provide some indication of the potential damage and flooding a hurricane will cause upon landfall.

Saffir–Simpson scale

The Saffir–Simpson hurricane wind scale is based on the highest wind speed averaged over a one-minute interval 10 m above the surface. Although the scale shows wind speeds in continuous speed ranges, the National Hurricane Center and the Central Pacific Hurricane Center assign tropical cyclone intensities in 5-knot (kn) increments (e.g., 100, 105, 110, 115 kn, etc.) because of the inherent uncertainty in estimating the strength of tropical cyclones. Wind speeds in knots are then converted to other units and rounded to the nearest 5 mph or 5 km/h.

Saffir–Simpson scale

The Saffir–Simpson hurricane wind scale is used officially only to describe hurricanes that form in the Atlantic Ocean and northern Pacific Ocean east of the International Date Line. Other areas use different scales to label these storms, which are called cyclones or typhoons, depending on the area. These areas (except the JTWC) use three-minute or ten-minute averaged winds to determine the maximum sustained wind speed, creating an important difference which frustrates direct comparison between maximum wind speeds of storms measured using the Saffir–Simpson hurricane wind scale (usually 14% more intense) and those measured using a ten-minute interval (usually 12% less intense).

Saffir–Simpson scale

There is some criticism of the SSHWS for not accounting for rain, storm surge, and other important factors, but SSHWS defenders say that part of the goal of SSHWS is to be straightforward and simple to understand.

History

The scale was developed in 1971 by civil engineer Herbert Saffir and meteorologist Robert Simpson, who at the time was director of the U.S. National Hurricane Center (NHC). The scale was introduced to the general public in 1973, and saw widespread use after Neil Frank replaced Simpson at the helm of the NHC in 1974.

The initial scale was developed by Herbert Saffir, a structural engineer, who in 1969 went on commission for the United Nations to study low-cost housing in hurricane-prone areas. While conducting the study, Saffir realized there was no simple scale for describing the likely effects of a hurricane. Mirroring the utility of the Richter magnitude scale for describing earthquakes, he devised a 1–5 scale based on wind speed that showed expected damage to structures. Saffir gave the scale to the NHC, and Simpson added the effects of storm surge and flooding.

In 2009, the NHC made moves to eliminate pressure and storm surge ranges from the categories, transforming it into a pure wind scale, called the Saffir–Simpson Hurricane Wind Scale (Experimental) [SSHWS]. The new scale became operational on May 15, 2010. The scale excludes flood ranges, storm surge estimations, rainfall, and location, which means a Category 2 hurricane that hits a major city will likely do far more cumulative damage than a Category 5 hurricane that hits a rural area. The agency cited various hurricanes as reasons for removing the "scientifically inaccurate" information, including Hurricane Katrina (2005) and Hurricane Ike (2008), which both had stronger than estimated storm surges, and Hurricane Charley (2004), which had weaker than estimated storm surge. Since being removed from the Saffir–Simpson hurricane wind scale, storm surge predicting and modeling is now handled with the use of computer numerical models such as ADCIRC and SLOSH.