A third person has been mentioned as the inventor both of the jenny and of roller-spinning, Thomas Highs, of Leigh, above-mentioned, whose claims seem entitled to more courteous notice than they have met with in the Edinburgh Review. There is nothing unreasonable in supposing that both Highs and Arkwright may have heard of Wyatt’s method of spinning by rollers, which was practised in two factories, one erected at Birmingham, the other at Nottingham.

“The factory system in England takes its rise from this period. Hitherto the cotton manufacture had been carried on almost entirely in the houses of the workmen: the hand or stock-cards, the spinning-wheel, and the loom, required no larger apartment than that of a cottage. A spinning-jenny of small size might also be used in a cottage, and in many instances was so used; when the number of spindles was considerably increased, adjacent workshops were used. But the water-frame, the carding-engine, and the other machines which Arkwright brought out in a finished state, required both more space than could be found in a cottage, and more power than could be applied by the human arm. Their weight also made it necessary to place them in strongly-built mills, and they could not be advantageously turned by any power then known but that of water.”

The Gallery of Portraits: with Memoirs. Vol 5 (of 7) — Part 145

“The use of machinery was accompanied by a greater division of labour than existed in the primitive state of the manufacture; the material went through many more processes, and of course the loss of time and the risk of waste would have been much increased, if its removal from house to house at every stage of the manufacture had been necessary. It became obvious that there were several important advantages in carrying on the numerous operations of an extensive manufacture in the same building. Where water-power was required, it was economy to build one mill, and put up one water-wheel, rather than several. This arrangement also enabled the master-spinner himself to superintend every stage of the manufacture; it gave him a greater security against the wasteful or fraudulent consumption of the material; it saved time in the transference of the work from hand to hand; and it prevented the extreme inconvenience which would have resulted from the failure of one class of workmen to perform their part, when several other classes of workmen were dependent upon them. Another circumstance which made it advantageous to have a large number of machines in one manufactory was, that mechanics must be employed on the spot to construct and repair the machinery, and that their time could not be fully occupied with only a few machines.”

The Gallery of Portraits: with Memoirs. Vol 5 (of 7) — Part 145