[Illustration: Head of Ivory-billed Woodpecker.]
Any one who has lived in a granite country knows the deep round holes that stone masons make when they split rock. Did you ever wonder why they are as large at the bottom as at the top? If you remember the shape of a mason's drill, you will recollect that it looks a little like a stick of home-made molasses candy bitten off when it was just soft enough to stretch a little. The mason's drill is a round iron rod with a thin, flat end, sharpened on the edge and a little pointed in the centre. In the flattening of the sides and the width across the tip its end resembles that of a typical woodpecker's bill. The woodpeckers that drill for grubs, especially the largest, the logcock and the ivory-billed woodpecker, have the tip remarkably flattened. The likeness to the drill does not go farther because the woodpecker's bill is a combination tool; but it is drill-pointed rather than pick-pointed.
What is the advantage of this compressed tip? Can the bird pick as well as he could with a sharp point? The bird and the mason reap the same benefit from this form of tool. A sharp-pointed drill would bind in the hole and could neither be driven ahead nor removed without difficulty, but the sharp-edged tool cuts a hole as wide as the instrument. There is, of course, some difference between working in stone and in wood, but the principle is the same. The mason strikes his drill with his hammer and cuts a crease in the stone; then lifts and turns the drill, cutting a crease in another direction; and so by continually changing the direction of the cuts until they radiate from a centre like the spokes of a wheel, he finally reduces a little circle of stone to a powder fine enough to be blown out of the hole. In drilling for a grub the woodpecker must do much the same thing. He wishes to keep his hole small at the top so as to save work, yet it must be large enough at the bottom to admit the borer when nipped between his mandibles; therefore he needs an instrument that, like a drill or a chisel, will cut a straight-sided hole. Indeed, we might call it a chisel just as well if it were not a double-wedge instead of a single wedge and if it did not move when it is struck instead of being held stationary beneath the blows.