[Illustration: FIG. 2.--Lean-to Plant House.]
Plant houses must be as far as possible impervious to wet and cold air from the exterior, provision at the same time being made for ventilation, while the escape of warm air from the interior must also be under control. The most important part of the enclosing material is necessarily glass. But as the rays of light, even in passing through transparent glass, lose much of their energy, which is further weakened in proportion to the distance it has to travel, the nearer the plant can be placed to the glass the more perfectly will its functions be performed; hence the importance of constructing the roofs at such an angle as will admit the most light, especially sunlight, at the time it is most required. Plants in glass houses require for their fullest development more solar light probably than even our best hot-houses transmit--certainly much more than is transmitted through the roofs of houses as generally constructed.
Plant houses constructed of the best Baltic pine timber are very durable, but the whole of the parts should be kept as light as possible. In many houses, especially those where ornament is of no consequence, the rafters are now omitted, or only used at wide intervals, somewhat stouter sash-bars being adopted, and stout panes of glass (usually called 21-oz.) 12 to 18 in. wide, made use of. Such houses are very light; being also very close, they require careful ventilation. The glass roof is commonly designed so as to form a uniform plane or slope from back to front in lean-to houses (fig. 2), and from centre to sides in span-roofed houses. To secure the greatest possible influx of light, some horticulturists recommend curvilinear roofs; but the superiority of these is largely due to the absence of rafters, which may also be dispensed with in plain roofs. They are very expensive to build and maintain. Span and ridge-and-furrow roofs, the forms now mostly preferred, are exceedingly well adapted for the admission of light, especially when they are glazed to within a few inches of the ground. They can be made, too, to cover in any extent of area without sustaining walls. Indeed, it has been proposed to support such roofs to a great extent upon suspension principles, the internal columns of support being utilized for conducting the rain-water off the roof to underground drains or reservoirs. The lean-to is the least desirable form, since it scarcely admits of elegance of design, but it is necessarily adopted in many cases.