In this way, the time both for fixing and removing the machines and of boring is reduced to a minimum, and thus two conditions favourable to rapid and economical progress is ensured. It is evident that when this system is followed, the face will not require the same number of holes at each blast. Another circumstance operating to increase the number of shot-holes is the desirability of bringing down the face in fragments small enough to be lifted without great difficulty. When the rock is completely broken up, the labour, and, consequently, the time of removing it after each blast, are lessened in an important degree. Hence there will be an advantage in placing the shot-holes sufficiently close together to ensure the fracture of the mass between each. These circumstances render it necessary to bore a large number of holes when the work is done by mechanical means. The boring of the additional holes reduces the superiority of machine over hand labour, and the additional quantity of the explosive required augments the cost of the work. To counterbalance these disadvantages, the shot-holes should be bored deep. It has already been pointed out that when a hole is once started with a machine, the rate of progress is immensely superior to that attained in hand boring, and to profit by this advantage, the hole should be continued to as great a depth as practicable. This is sufficiently obvious, since it amounts to increasing the proportion of the whole time consumed that is occupied in actual boring; for as it is in the rapidity of the operation of boring alone that the superiority of machine labour exists, it is plain that the longer the proportion of the time so occupied, the more marked that superiority will be. Thus, by increasing the depth of the holes to the farthest practicable limit, we approximate as much as possible to the condition most favourable to machine boring. The intermediate system, therefore, which takes full advantage of this means, will lead to the best results. To recapitulate the main points of such a system; it should follow the lines of least resistance when that can be conveniently done, and neglect them when the fulfilment of their requirements would occasion a considerable expenditure of time; and to counterbalance the disadvantages of machine boring, it should employ shot-holes of as great a depth as is practicable.