When the fire is well under way and blazing brightly at all points, pile on it plenty of split sticks, short, and as near a uniform size as possible, and let them all burn to coals before cooking is commenced. If some of the sticks are large and some small, they will not burn evenly, and by the time the larger ones have become coals, the coals of the smaller ones will have become ashes. And if the sticks are round instead of split, they will not catch fire so easily, and will nest so close together as to give insufficient draft. Driftwood will do to start a fire, but it should never be used after the blaze is well going, because it burns to ashes instead of coals. The best coals result from burning hard wood. Never put a cooking utensil on the fire until the smoke and blaze have ceased. When you have a good bed of coals set the coffee pot on near where the logs join, and the frying pan, large pot, etc., where the logs are further apart. If there is much wind, ashes will be blown about to some extent, and it is best to always keep the open end of the "range" to windward, as the frying pan is generally set on this end, while the coffee pot and other pots being covered, can stand a shower of ashes without harm to their contents. As fast as one dish is cooked, set it on one of the logs where it will keep warm, and use the handy blacksmith's pliers to heap up the live coals under other dishes that are not cooking fast enough.
These pliers can be made by any blacksmith, and should be from twelve to eighteen inches in length, and quite broad in the gripping part, which may with advantage be curved to a slight angle. I always use a frying pan without handle for compactness, and can lift it from any side of the fire with the pliers, which are always cool. I even grip the coffee pot with them and pour the coffee for the whole party without touching it with my hands, saving many a scorch thereby. It is a handy tool in making repairs to boats, and in various other ways proves its value as a necessary part of the camp outfit. The coffee pot should not have a spout, but a lip, riveted on, near its topmost edge. The handle should also be riveted, and should set as near as possible to the top of the pot. A wire bale may be attached for handiness in lifting.