The TVR Grantura is the first production model in a long line of TVR cars. It debuted in 1958 and went through a series of developments leading to the Mark I to Mark IV and 1800S models. The last ones were made in September 1967.

These coupés were hand-built at the TVR factory in Blackpool, England with varying mechanical specifications and could be had in kit form. All cars featured a cocktail of Austin-Healey brakes, VW Beetle or Triumph suspension parts and BMC rear axles.

TVR Grantura

The Grantura bodyshell was made from glass-reinforced plastic and made use of a variety of proprietary components. The bonnet was front hinged. There was no opening at the rear but the boot could be accessed from inside the car - the spare wheel had to be removed through the front doors. Buyers could choose from a range of powerplants which, dependant on the model in question, included a choice of side or overhead valve engines from Ford, a Coventry Climax unit, the engine from the MGA and, ultimately, the 1798cc BMC B-series engine.

TVR Grantura

Mark I

The first of the Granturas used a fibreglass body moulded to a tubular steel backbone chassis and VW Beetle-based front and rear suspension. At the rear, the VW suspension was married to an inboard diff (housing an MGA differential) connected to hardy spicer joints, with short driveshafts to the independently sprung hubs. This was an advanced feature at a time when most other cars had cart-spring rear suspension. The car was designed around a 1098 cc Coventry Climax type FWA engine but many different makes were fitted from 1172 cc Ford side valve to 1600 cc BMC from the MGA. The drum brakes originated on the Austin-Healey 100 and the windscreen on the Ford Consul.

TVR Grantura

Approximately 100 of the Mark I Grantura were built from 1958 to 1960.

Mark II/IIa

The Mark II had MGA engines as standard but again customers could choose from a variety of power units. The Mark IIa used the 1622 cc MGA Mark II or Ford 1340 cc engine. The more expensive Coventry Climax FWA 1216 cc that was also found in the Lotus Elite was also available. Front disc brakes were standard for the Mk IIa. Rack and pinion steering was standardised.

A car with a 1600 cc MGA engine was tested by the British magazine The Motor in 1961. It had a top speed of and could accelerate from zero to in twelve seconds. Fuel consumption of was recorded. The test car cost £1,298 including taxes.

Approximately 400 of the Mark II/IIa Grantura were built.

Mark III, Mark III 1800, 1800S and Mark IV

The next series of cars had a completely new, longer and stiffer chassis with innovative coil sprung independent suspension. This chassis was designed by John Thurner and would form the basis of the one used by TVR up to the launch of the 2500M cars in 1972. The Mark III also received a new front end design, with the grille mounted higher and featuring some rudimentary chrome trim.

The Mark III and the later Mark III 1800 cars used BMC B-series engines, either 1622 or 1798 cc respectively, although Ford or Coventry Climax units were also available for the earlier Mark III model. The larger capacity 1798 cc MG 'B' series engine became standard equipment around September 1963 although this more powerful engine appears to have been available as a customer-specified option prior to that date. At some point during 1963 the rear of the car was reprofiled to include a number plate mount.

In 1965 the latest version of the car became available as the 1800S with a cut off, square back (called a 'Manx tail' after the similarly tailless breed of cat) and round rear light clusters from the Ford Cortina. The 1798cc B-series engine remained but the chassis used for the 1800S and all subsequent Granturas was a modified version that, through an alteration to the line of the top chassis rails, allowed more space for the engine to fit in. This was an alteration made to the Grantura chassis to allow it also to be used as the basis for the new Griffith, a car that sported a V8 engine which was larger both in capacity and physical dimension.

After a pause in production during late 1965, under Martin Lilley's new ownership the 1800S reappeared in early 1966 rebadged as the Mark III 1800S. This was quickly followed by the new Mk IV model. The Mk IV featured a longer wheelbase, more luxurious trim and a larger fuel tank and was the first TVR to benefit from Martin Lilley's influence.

Approximately 300 of the Mark III, Mark III 1800, 1800S and MkIV cars were built (estimated to be 60 of the Mark III, 30 to 35 of the Mark III 1800, 128 of the 1800S / Mark III 1800S and 78 of the Mk IV) before being replaced in 1967 by the Vixen.