But when the room push is pressed its bell is cut out and the circuit becomes like an ordinary annunciator circuit.

=Three Wire Return Call System.= A three wire return call annunciator system is shown in Fig. 60.

How to Install Electric Bells, Annunciators, and Alarms. — Part 24

There are two battery wires installed, from which taps are taken off and led to each room or push button.

How to Install Electric Bells, Annunciators, and Alarms. — Part 24

Three way or return call push buttons are used as shown at points marked _B_.

How to Install Electric Bells, Annunciators, and Alarms. — Part 24

In the diagram, the bells are marked _A_, the drops in the annunciator _D_, the annunciator bell _C_ and the return call buttons in the annunciator _E_. The batteries are as shown at _F_. The heavy black outline encloses the annunciator mechanism and connections which are drawn diagrammatically for the sake of clearness.

Three stations only are shown on the sketch, but the annunciators which are manufactured by Edwards and Co., Inc., of New York, are made in all standard sizes.

=Installing Elevator Annunciators.= The installing of electric bells and annunciators in elevators does not present any special problems, although the apparatus used must be selected with a view to its being suitable to withstand the shocks incident to elevator service.

In general the wires leading from the push buttons on the different floors to the bell or annunciator in the elevator, are flexible and made up into a cable. One end of this cable is attached to the underside of the elevator car, the other end being fixed usually to the elevator wall, at a point midway between the top and bottom of the shaft.

In Fig. 61 is shown a diagram of the general circuit used, details of course differing in each installation.

One point to be taken care of in elevator work is the attachment of the cables. The continual movement tends to break the wires at the two ends if good flexible cable is not used and the installation done in a workmanlike manner.

Elevator cable is a standard article and may be procured through any electrical supply store. That most commonly used consists of the requisite number of copper conductors each composed of 16 strands No. 30 B. and S. gauge soft and untinned copper wire. These flexible conductors are insulated with two reverse wrappings of cotton and one braid of cotton. The insulated conductors are cabled together with a steel supporting strand where extra tensile strength is required, as in the case of extra long cables. The number of conductors generally ranges from 3 to 20 inclusive.