_Austrian and French Boats._--The next size of torpedo vessel is that supplied to the Austrian and French governments, which is shown at Fig. 151. The dimensions are:--length, 67 feet; beam, 8 feet 6 inches; draught of water, 4 feet 3 inches. The guaranteed speed in the case of the Austrian boat was 15 knots in a run of one hour's duration, and in the case of the French boats 18 knots, in a run of two hours' duration. These boats were built of somewhat thicker plating than the 57 feet type, and the armour was extended.
They were divided into six water-tight compartments, and they differed from the Scandinavian boats in having the spaces forward and aft of the machinery permanently decked, instead of being covered with movable steel covers only.
The machinery was somewhat similar to that in the Scandinavian boats, excepting that the engines were capable of developing 200 indicated horse power, and that the air was supplied to the furnace by being forced into an air-tight stoke hole, instead of being forced directly under the fire grate.
The armament of these vessels consisted of two torpedoes attached to the end of wooden poles, 4-1/2 inches diameter and about 43 feet long, connected to the battery by insulated wires, and arranged to be fired either by coming in contact with the enemy's vessel or at any distance from it, at the will of the operator.
The torpedoes themselves were simply copper cases, of sufficient size, in the case of the Austrian boat, to contain 11,000 cubic centimetres of explosive, and in the case of the French boats, to contain 25 kilogrammes of dynamite.
The mode of arranging the wires is similar to that explained at page 155. The method of manipulating the torpedo poles consists of two tubes riveted together at right angles, so as to form something like the letter T. The torpedo pole is put through the horizontal tube, which is free to move round the centre of the vertical tube, and the vertical tube is free to move through a quarter circle at right angles to the centre line of the vessel.
In attacking in front, the vertical tube is laid over till it is parallel to the water surface, and the horizontal tube is allowed to incline sufficiently far to allow of the end of the pole, when run out, to be depressed from 8 to 10 feet below the water-line. It is held in this position by a pair of blocks attached to the top of a short mast.