Before leaving this part of the subject, however, I may mention a relation which is very easily remembered, and is very nearly exact—much more so, at any rate, than that of Archimedes. Write down the numbers 113,355, that is, the first three odd numbers each repeated twice over. Then separate the six numbers into two sets of three, thus,—113) 355, and proceed with the division thus indicated. The result, 3·1415929..., expresses the circumference of a circle whose diameter is 1, correctly to the sixth decimal place, the true relation being 3·14159265.
Again, many people imagine that mathematicians are still in a state of uncertainty as to the relation which exists between the circumference and the diameter of the circle. If this were so, scientific societies might well hold out a reward to anyone who could enlighten them; for the determination of this relation (with satisfactory exactitude) may be held to lie at the foundation of the whole of our modern system of mathematics. I need hardly say that no doubt whatever rests on the matter. A hundred different methods are known to mathematicians by which the circumference may be calculated from the diameter with any required degree of exactness. Here is a simple one, for example:—Take any number of the fractions formed by putting _one_ as a numerator over the successive odd numbers. Add together the alternate ones beginning with the first, which, of course, is unity. Add together the remainder. Subtract the second sum from the first. The remainder will express the circumference (the diameter being taken as unity) to any required degree of exactness. We have merely to take enough fractions. The process would, of course, be a very laborious one, if great exactness were required, and as a matter of fact mathematicians have made use of much more convenient methods for determining the required relation: but the method is strictly exact.
The largest circle we have much to do with in scientific questions is the earth’s equator. As a matter of curiosity, we may inquire what the circumference of the earth’s orbit is; but as we are far from being sure of the exact length of the radius of that orbit (that is, of the earth’s distance from the sun), it is clear that we do not need a very exact relation between the circumference and the diameter in dealing with that enormous circle. Confining ourselves, therefore, to the circle of the earth’s equator, let us see what exactness we seem to require. We will suppose for a moment that it is possible to measure round the earth’s equator without losing count of a single yard, and that we want to gather from our estimate what the diameter of this great circle may be. This seems, indeed, the only use to which, in this case, we can put our knowledge of the relation we are dealing with. We have then a circle some twenty-five thousand miles round, and each mile contains one thousand seven hundred and sixty yards: or in all there are some forty-four million yards in the circumference, and therefore (roughly) some fourteen million yards in the diameter of this great circle. Hence, if our relation is correct within a fourteen-millionth part of the diameter, or a forty-four millionth part of the circumference, we are safe from any error exceeding a yard. All we want, then, is that the number expressing the circumference (the diameter being unity) should be true to the eighth decimal place, as quoted above (p. 291, l. 5).