The last wipe should be a quick stroke coming off of joint on a tangent. If the solder is at right heat, the cloth will not leave a noticeable mark. If, however, the solder is too cold, a ragged edge will result. Sometimes a cross wipe is made for the last stroke and a good finish obtained.

_First_, width of the joint, 2-1/2 inches.

Elements of Plumbing — Part 16

_Second_, allow no soil or paste to get on the joint.

Elements of Plumbing — Part 16

_Fourth_, 500° is the working heat of solder.

Elements of Plumbing — Part 16

_Seventh_, do not drop solder on the lead pipe.

_Eighth_, hold the ladle 2 inches above the pipe.

_Ninth_, wipe the edges of the joint first.

_Tenth_, wipe and shape the joint quickly.

The above procedure of wiping will be found to work out very easily if followed closely. Do not pour the hot solder onto the cloth as the cloth will burn through and soon be useless. A little more oil should be put on the cloth after using it for awhile. The cloth should be turned around and the opposite side also used. The cloth will last considerably longer if sides are changed frequently. The solder should not accumulate on the pan, but should be continually put back into the pot. The "metal," as solder is sometimes called, should never be allowed to become red hot.

The above method of preparing pipe is suggested for beginners only and will be found to be a great help to them. In actual practice the joint must be prepared differently. The method used in trade is as follows:

The joint is used to join two pieces of lead pipe. Take two pieces and rasp the four ends square. With the tap borer clean out the end of one pipe a trifle, then with the turn pin enlarge this end just a little as shown in the figure. Then rasp the edge off about 1/8 inch as shown. Take the other piece of pipe and rasp one end as was done in the cup joint, making it fit into the first piece. Then place the two ends together and with the bending iron beat the pipe, making the joint as tight as possible.

The next position in which the beginner is to wipe a joint is on an angle of 45° to the right.

PREPARATION.--To prepare this joint, proceed as in the horizontal round joint. I will enumerate a few of these points. A piece 12 inches long of 1/2-inch pipe is cut off and the ends squared. A strip in the center, 6 inches long, is shaved clean. Paper and paste are put over the pipe except 2-1/2 inches in the center. Grease can be put on the pipe in between the pieces of paper and will keep the lead from oxidizing.