In late fall and winter, sifting provides one of the most profitable types of collecting; in any season, it will turn up such things as rare spiders and beetles. Sifting is most successful for finding large, active insects. For small, slow-moving forms, Berlese funnels offer a better collecting method.
When you are wandering through woods or fields, do you realize that you are stepping on more insects than you ever see? The ground cover and soil are inhabited by a vast assemblage of little animals that are seldom seen by the casual collector. Because many of these animals are exceedingly minute, they are difficult to see and collect by ordinary methods.
Construction.--The most efficient method for collecting this fauna is by the use of Berlese funnels, named after the Italian entomologist Berlese (pronounced Bur-lazy), who first used them extensively. A Berlese funnel is a very simple apparatus, consisting of a fairly long funnel, suspended wide end up, with, a screen placed about a third of the way down the funnel; heat is applied either around the upper portion or over the top of the funnel, and a container of preservative, preferably 80 per cent ethyl alcohol, is placed at the small bottom opening. Leaf mold or other material is placed on the screen, the heat source is turned on, and soon the animals begin to leave the drying sample and migrate downward, dropping into the preservative.
[Illustration: Fig. 7.--Diagrammatic cross section of a Berlese funnel. The central figure shows an arrangement for a steam coil, the lower left for an electric light.]
Fig. 7 illustrates a funnel that has proved very satisfactory; it is 15 inches from top to bottom, and the top has a diameter of 12 inches. The bottom opening, seven-eighths inch in diameter, fits into the mouth of the bottle containing the preservative. Three angled brackets or hangers are soldered inside the funnel to provide a rest for the screen, which is made of quarter-inch or eighth-inch mesh hardware cloth; the mesh used depends upon the type of sample. A battery of several funnels in a rack, fig. 8, will allow the collector to sample several kinds of material at the same time.
If steam is used as a source of heat, the small copper lines that conduct it act as a partial support for the funnel by encircling it about halfway between the screen and the top; a piece of cloth is tied tightly over the top of the funnel to prevent the upward escape of animals. If an electric light is used for heating, it should be hung directly over the center of the funnel, no cloth should be tied over the top, and the light should have a reflector nearly as wide as the top of the funnel.