The system consists of tape units connected to the PDP-3 through a tape control (TC). This tape is read or written in IBM 729I format. Two hundred characters, each having 6 bits plus a parity bit, are written on each inch of tape and the tape moves at 75 inches/sec. The tape control has the job of connecting a specific unit to the PDP-3 and is a switch. It also has the function of controlling the format of information that is read or written on tape. In-out class commands instruct TC to the type of information transfer and select the tape unit. Another IOT command synchronizes the transfer of information through the TC to the computer.
The IOT order to select the unit and function is decoded as follows: 1) Three bits specify the function of TC. 2) The remaining 6 bits select the unit.
_IOT Motion Commands for Magnetic Tape Units_
73....nn 60 mrb Read a binary record. 73....nn 61 mra Read an alphanumeric (BCD) record. 73....nn 62 mbb Backspace a binary record. 73....nn 63 mba Backspace an alphanumeric record. 73....nn 64 mwb Write a binary record. 73....nn 65 mwa Write an alphanumeric record. 73....nn 66 mlp Move tape to lead point (rewind).
Where the octal digits, nn, specify the unit number.
The motion commands have the deferred bit, thus, the program halts. If the TC is free, the command will be transferred to the tape control for action and the program restarts immediately. If the tape control is currently busy with an instruction, i.e., it hasn't finished a previous command, the motion command is held up until TC is free to execute the new command.
The transfer of information from the computer to the TC is accomplished with the pause and skip command, MPS or IOT 70. This command has the deferred bit and halts a program until the TC can handle the transfer. On completion, the transfer occurs and the program restarts. This is used exclusively to synchronize the flow of information between a tape unit and the computer. This command normally skips the following instruction. If a flag is set in the TC, indicating incorrect information flow, the skip does not take place.
The TC contains a 36 bit buffer which holds a complete word while information is read or written. When an MPS order is given and the unit is reading, the TC buffer is read into the IO. The MPS order given during writing causes the IO to be transferred to the TC buffer.