Attached to the upper end of the inner frame by hinges was a thin and narrow frame, called the "frisket," of the same length and width as the inner tympan frame. This frisket was covered with strong paper in which were openings, cut a little larger than the size of the pages of the type-form. When the sheets of paper had been placed upon the tympan frame, the frisket was folded down upon it, and the two were then turned down over the form of type. The bed was then "run in" under the platen by means of a crank at the side of the press, and the platen was screwed down to make the impression. After the impression had been taken, the platen was screwed up, the bed "run out," the tympan frame and frisket lifted, and the printed sheet taken off.

The introduction of this Stanhope press gave a great impetus to the development of the printing press in other countries as well as in England, and many varieties were devised during the thirty years following. Although as early as 1811 Koenig had made a cylinder press which had proved fairly successful, the better grades of printing could be obtained only by the flat pressure of the hand-presses. In some of these hand presses, the platen, or upper impression plate, was moved into position over the bed and remained stationary while the bed with the type-form upon it was forced upward to make the impression. In others, the platen was hinged to the bed, but in all of them the mechanism was complicated.

The Building of a Book — Part 58

The "Columbian" press, devised by George Clymer, of Philadelphia, in 1816, gained considerable distinction both in this country and in England, where it was introduced in 1818. It differed from the Stanhope in that the screw was dispensed with, the platen being depressed by a combination of levers and lifted by the aid of a weighted balance-lever.

The Building of a Book — Part 58

The reduction of the hand-lever movement to its simplest and most powerful form is now seen in the Washington hand press, devised by Samuel Rust, of New York, in 1827. His patent was later purchased by R. Hoe & Co., who made nearly seven thousand of these presses in different sizes and still make many of a greatly strengthened pattern for taking fine proofs from photo-engraved plates. Some of these presses made before 1850 are still in use, and occasionally one hears of a Washington hand press being used for printing upon handmade paper an edition of a small and limited number of copies of a book. Of all the hand presses, this is the only one that has survived to the present day.

The Building of a Book — Part 58