This action and reaction are practically those that take place in the Edison alkaline storage battery. For simplicity of illustration we will consider a cell containing only two plates, one positive and one negative.
The negative plate is made up of a number of small, flat, perforated pockets containing iron oxide in the form of a fine powder. The positive plate is made up of small, perforated tubes containing nickel oxide mixed with very thin flakes of metallic nickel. (Fig. 37 illustrates these plates, the positive being in front.)
These two elements, positive and negative, having wires or conductors attached, are placed in a nickeled-steel can containing the electrolyte, which consists of a potash solution. You will see that this differs from a lead storage battery, in which the electrolyte is sulphuric acid and water. If we were to put this acid solution into a metallic can (except one made of lead) the can would not last long, as the acid would quickly eat holes through it.
Now let us see what takes place in the Edison alkaline storage battery. If an electric current from a dynamo or other source of electricity is caused to pass through the positive to the negative plate the oxygen present in the iron oxide passes to and remains with the nickel oxide. During all the time this is going on the battery is said to be "charging," and when all the oxygen has been removed from the iron oxide and is taken up by the nickel oxide, then the battery is said to be "charged," and the flow of current into the battery is stopped.
A change has now taken place. The powder in the negative plate is no longer iron oxide, but has been reduced to metallic iron, because the oxygen has been removed. The powder in the positive plate is now raised to a higher or super oxide of nickel, because it has taken the oxygen that was in the iron.
But the nickel oxide will readily give up its excess of oxygen, and the iron will receive it back freely if permitted. If the proper conditions are established, this transfer of oxygen will take place, but the iron cannot receive it without delivering energy.
The proper conditions are established by providing a conducting circuit between the two elements, in which lamps, motors, or other electrical devices are placed. As soon as this circuit is provided, the opportunity is given to the iron to receive the oxygen. This it does, and in so doing develops electrical energy.