The water is brought from a ditch on the high ground, and through a line of pipes to the distributing box, whence the branch pipes supplying the jets diverge. The stream issues through a nozzle, termed a "monitor" or "giant," which is fitted with a ball and socket joint, so that the direction of the jet may be varied through considerable angles by simply moving a handle. The material of the bank being loosened by blasting and the cutting action of the water, crumbles into holes, and the superincumbent mass, often with large trees and stones, falls into the lower ground. The stream, laden with stones and gravel, passes into the sluices, where the gold is recovered in the manner already described. Under the most advantageous conditions the loss of gold may be estimated at 15 or 20%, the amount recovered representing a value of about two shillings per ton of gravel treated. The loss of mercury is about the same, from 5 to 6 cwt. being in constant use per mile of sluice.
In working auriferous river-beds, dredges have been used with considerable success in certain parts of New Zealand and on the Pacific slope in America. The dredges used in California are almost exclusively of the endless-chain bucket or steam-shovel pattern. Some dredges have a capacity under favourable conditions of over 2000 cub. yds. of gravel daily. The gravel is excavated as in the ordinary form of endless-chain bucket dredge and dumped on to the deck of the dredge. It then passes through screens and grizzlies to retain the coarse gravel, the finer material passing on to sluice boxes provided with riffles, supplied with mercury. There are belt conveyers for discharging the gravel and tailings at the end of the vessel remote from the buckets. The water necessary to the process is pumped from the river; as much as 2000 gallons per minute is used on the larger dredges.
The dressing or mechanical preparation of vein stuff containing gold is generally similar to that of other ores (see ORE-DRESSING), except that the precious metal should be removed from the waste substances as quickly as possible, even although other minerals of value that are subsequently recovered may be present. In all cases the quartz or other vein stuff must be reduced to a very fine powder as a preliminary to further operations. This may be done in several ways, e.g. either (1) by the Mexican crusher or _arrastra_, in which the grinding is effected upon a bed of stone, over which heavy blocks of stone attached to cross arms are dragged by the rotation of the arms about a central spindle, or (2) by the Chilean mill or _trapiche_, also known as the edge-runner, where the grinding stones roll upon the floor, at the same time turning about a central upright--contrivances which are mainly used for the preparation of silver ores; but by far the largest proportion of the gold quartz of California, Australia and Africa is reduced by (3) the stamp mill, which is similar in principle to that used in Europe for the preparation of tin and other ores.