It is best to remove the contact screw and vibrator blade for examination and cleaning, as it is much easier to file the points square and straight when removed from the coil.
Be careful not to bend the vibrator spring when cleaning, as the adjustment will be impaired. When replacing contact screw and vibrator blade in coil, be careful that they are in exactly the same relative position as they were before removing. Also be sure that the contacts meet and bear uniformly on their surfaces.
The duty of the primary timer is to close the primary circuit of the spark coil at, or a little before the time at which the explosive of the charge is required. The exact time at which the timer closes the circuit depends on the load, the speed, and the nature of the fuel. The lapse of time between the instant that the timer closes the circuit and the instant at which the piston reaches the end of the compression stroke is called the “advance” of the timer. When the timer closes the circuit after the piston reaches the end of the stroke, the timer is said to be “retarded.” The timer is constructed so that the time of ignition or the advance and retard can be varied between wide limits. Advancing the spark too far will cause hammering and power loss as the piston will work against the pressure of the explosion.
Retarding the spark will cause a loss of power, as the compression will be less when the piston starts on the outward stroke; and also for the reason that more of the heat will be given up to the cylinder walls as the combustion will be slower. The pressure in the cylinder is less with retarded ignition. Greatly retarded ignition often causes overheating of the cylinder walls, especially with air cooled engines, and also overheats and destroys the seat and valve stem of the exhaust valve. Do not expect the engine to develop its rated horse-power or run efficiently with a late, or retarded spark.
When the engine is installed, and before the timer wears or has a chance to get out of adjustment, look it over carefully and see whether the maker has left any marks relating to the timing of the spark. If there are no marks, it is well to determine the relation between the position of the piston and the timer, as the efficiency of the engine depends to a great degree upon the firing point.