After this another impression is taken, and of this sheet an "underlay" is made to further "even up" the form. The low places in the individual plates are carefully marked with crayon or a soft pencil on the impression, and the spots so marked are covered with a piece of thin paper. The printed pages are then cut out a little larger than the type page, and placed under the plates from which they were printed. The plates of the solid pages, which had been substituted for the open pages, are now removed, and the open pages are put back in their places on the form.
Up to this point, all the "making ready" which has been done, is of permanent use in printing all of the forms of the book in question. The work that follows has to be done on each form as it is put on the press.
More thin sheets of paper are now run through the press, the number run through together being one less than were printed for the underlay. These printed sheets are used for "overlays," which are very much like an underlay except that much more care is taken in marking any uneven places. A thinner paper is used to bring up the low places in the plates. An impression of the form is then made on the manila paper sheet which had, as before mentioned, been drawn around the cylinder, and on this printed manila sheet this overlay is pasted, the impression on the manila paper being a guide for the placing of the overlay.
Another overlay is now made in the same way as the first; only it will now be found, if the work has been properly done, that there will be only a few spots to be covered with tissue. After this overlay has been made and the necessary pieces pasted over the first one, a thin sheet of manila is smoothly and tightly drawn around the cylinder, covering completely the thick manila sheet with the pasted overlays on it. The form is then ready to print.
While the feeder, as the man who feeds the paper into the press is called, has been "filling in" the overlay, the pressman should have been getting "register,"--that is, moving the plates so that the headlines and the sides of the plates align properly, and that when both sides of the paper have been printed, the pages will exactly back each other. The ink fountain should also have been so regulated by means of thumb-screws that the right amount of ink will run on the rollers and be distributed evenly over the form. Where too much ink shows on the printed sheet, the thumb-screws on the fountain are tightened a little, to decrease the flow, and where not enough ink shows the thumb-screws are loosened to increase its flow. This process is repeated until the "color" is all right. The grippers, which seize and carry the sheets of paper through the press, the reels, cylinder bands, and many other things have also to be adjusted. These cannot well be described, but have to be learned by actual experience.