In setting out a line of railway or a canal care should be taken to avoid, if practicable, either cuttings or embankments in soil resting upon inclined rock, as slips are almost sure to occur. However, should it be unavoidable, their depth and height should be reduced to a minimum and, if possible, the formation be raised until the bare rock crops out, and this can frequently be effected within the limits of deviation. Also deep cuttings in clay or earth, having particles soon affected by weather, should be avoided, but they may be necessary; and should any have to be located upon a sharp curve, it is advisable to excavate the projecting spur on the convex side of the curve more than that required to obtain the formation width, as it is peculiarly exposed, and therefore more likely to slip. When cuttings are upon the escarpment of a clay hill the slope upon the valley side need not be so flat as that against the hill. An inclination of 3 or 4 to 1 may be necessary upon the hill-side, whereas a 1½ to 1 slope may be sufficient upon the other. When a slip may involve the destruction or injury of any adjacent buildings, the best plan is to erect a retaining wall at the foot of a slope, not less than about one-fourth of the height of an embankment or the depth of a cutting, ample provision being made for drainage and the expansion of the earth. It is a sure protection and support, and the consequences of a slip may be most serious in such a position. The protection of the slope and a breast wall may, however, be alone necessary upon the valley-side.

The construction of embankments upon soft soil is here referred to so far as regards lateral movement, or where vertical settlement causes such action by drawing asunder. Whenever the surface of the ground bulges or upheaves upon earth being tipped upon it or pressure applied, it shows that the disturbing harbingers of instability are in action and that its sustaining power has been reached, its surface ruptured, and any more soil placed thereon will only sink and displace the earth until it meets the solid ground beneath, or the material becomes sufficiently compressed and dense for it to sustain the load; such a condition of unrest generally proceeds from over-pressure and will loosen the soil, increase percolation, and aid disintegration. When it is known that soft, peaty, muddy, or silty earth overlies level solid ground, and it is certain it cannot escape, and can only be condensed by weighting until it will permanently bear the strain required, it can be built upon; although should there be more pressure at one place than another, or the character of the soil vary, in certain places be swampy and in others dry, the surrounding ground will probably rise where the weight is the least; therefore, increased bearing area of an embankment maybe necessary until the sustaining power of the earth is not exceeded, or slips and subsidences will occur, for the weight of an embankment in such a situation cannot be diminished by retaining walls, as stable foundations are not to be obtained. It is obvious the width of the formation cannot be reduced and therefore the only way of lessening the load upon the base per square foot, assuming the embankment to act as a mass, and of distributing its weight, is by flattening the slope and making a platform under the seat of an embankment. All earths, however, that are not hard rock subside upon being weighted, and in the case of tenacious clay soils, upon a considerable load being applied over a small area, a trifling contiguous uplifting of the ground will generally be noticed. If such rise of the soil does not exceed about one-sixth of the settlement of the clay under the load it may be disregarded as not likely to cause a slip or serious lateral movement.

Earthwork Slips and Subsidences upon Public Works — Part 108